Shop

BMS 3.5" Slip-On N55 & B58 Exhaust Tips

BMSEXHTIP

BMS 3.5" Slip-On N55 & B58 Exhaust Tips BMSEXHTIP

Give Your Factory N55 Exhaust An Attitude Adjustment

The BMS 3.5" slip-on exhaust tips are the perfect choice for dressing up your factory exhaust outlets. Made from stainless steel and etched with the BMS logo these are sure to turn heads. Specially equipped with factory-like pressure clips so they go on easily and stay in place just like the factory tips. No ugly screws or clamps for a factory appearance. These easy to install exhaust tips are offered in a variety of colors and cuts that are sure give your factory BMW exhaust system a grand look. Not for use with M-Performance exhaust systems. Does not fit any E chassis vehicles or other F chassis vehicles other than those listed below.

BMS 3.5" Slip-On Exhaust Tips Applications:

BMW 1 Series (NON-USA MODEL ONLY)
• 2013+ BMW F20 F21 N55 M135 (*see below)

BMW 2 Series
• 2014+ BMW F22 F23 N55 M235i/ix (*see below)

BMW 3 Series
• 2012+ BMW F30 F31 N55 335i/ix
• 2016+ BMW F30 B58 340i/ix
• 2012+ BMW F34 GT N55 335i/ix

BMW 4 Series
• 2014+ F32 F33 N55 435i/ix
• 2014+ F36 Gran Coupe N55 435i/ix

What's my BMW chassis code?

*F chassis M135 and M235 models will need to check your alignment dowel before ordering. If your alignment dowel is not straight up and down you can only get straight cut, no logo.

The alignment dowel on some early build M135 and M235 have an alignment dowel that is rotated inward 45º, unlike the straight up and down alignment dowel of the 335 and 435. If you get the logo tip, the logo or angle cut it will be turned 45º to the inside. Not for use with M-Performance exhaust systems. Does not fit any E chassis vehicles or other F chassis vehicles other than those listed above.

To install remove your factory tips by pounding outward on the lower part with either a rubber mallet or a hammer. A small piece of wood can be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small medium taps will start the factory tip sliding off the actual exhaust pipe. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. The logo and cutout must be facing straight up during this next procedure. Slide the BMS slip-on exhaust tip and slip it straight over the factory exhaust pipe. Carefully push the tip straight on until it stops. That's it.

Please note these tips are not suitable for extreme salty UK roads. Majority of our customers have no issues, coastal areas will struggle to keep these looking good. We advise only WD40 to clean these and help protect them. NO RETURNS for these items due to this.


£105
Colour Options Titanium Blue Angle (no logo) (0)
BMS 3.5" Slip-On N55 & B58 Exhaust Tips BMS 3.5" Slip-On N55 & B58 Exhaust Tips BMS 3.5" Slip-On N55 & B58 Exhaust Tips BMS 3.5" Slip-On N55 & B58 Exhaust Tips BMS 3.5" Slip-On N55 & B58 Exhaust Tips